This post was last edited by loveyanyu at 2016-4-1821: 48

Simply because Fengshang MAX, Card 1 supports Nanosim, Card 2 supports NanoSIM card or SD card, lots of pals feel that if they want to use a memory card, they can only place one particular SIM card, so it truly is not possible to utilize dual SIM cards, which can be a bit of a loss really feel. So is there a fantastic way to use dual SIM cards and memory cards in the very same time, actually, this system is there, lots of persons have written before, by means of DIY could make the memory card and SIM card share a card slot, Although there are several tutorials on the web, currently I would prefer to share this strategy with you cautiously. The actions are as follows:

The first step: prepare tool scissors, 502 glue, knife, MICROSIM card, or nanosim card, memory card;

Step 2: Prepare the SIM card, micro card or Nano card to become utilized! Very first reduce off the plastic parts about the micro card or Nano card with scissors to cut only the chip portion, then use the blade to gently pry off the chip. When prying off, make use of the blade to force in distinct directions. The chip is also glued for the plastic, don't forget that brute force should not be applied, so as to not pry the circuit on the chip. Take alter table recover partitions hive before prying the chip to remember the path with the chip, so as not to set up the incorrect chip path behind;

Step 3: Scrape off the bottom on the chip where the plastic portion is lifted gently with a blade, because the bottom in the chip is protected and raised, in order to stay away from the back into the card slot, so Require to scrape off some of the raised parts;

Step 4: Compare the SI | M card chip with all the SD card. If there is no size difference, you'll be able to straight stick to the SD card. If there's a difference, make use of the prepared scissors to cut precisely the same size on each sides with the card. Put how to recover a partition table gparted around the opposite side of Cato and make a gesture to view if there's any gap on each sides. Don't cut a lot of, or the contacts is going to be damaged!

The fifth component is to stick the SIM card chip with 502 on the side with the TF card out point. The distance above the edge is about 1MM away in the gold finger! alter table recover partitions hive example are able to put the SD card within the card slot for comparison. After the comparison, paste it with 502. The chip desires to be stuck in the middle in the left and suitable of the SD card (verify the path with the SIM card chip amongst the phones before sticking, and paste it) At that time, do n’t get glue for the position on the gold finger with the SD card plus the point with the sim card chip, otherwise it is going to cause the inability to get in touch with or the memory card to become unusable);

In the final step, put the sd card and Nanosim card together inside the card slot and set up it inside the phone. Try to remember, for those who ca n’t set up it, do n’t use brute force, shake the card slot, and gradually set up the card slot into the telephone. Otherwise, it's uncomplicated to create the SIM card unusable.

See the final impact, dual card + SD card, no longer have to worry about becoming unable to work with two SIM cards, or can only use a single SIM card and one particular SD card.

------ For extra tutorials, please remain tuned ------