This post was final edited by loveyanyu at 2016-4-1821: 48

Since Fengshang MAX, Card 1 supports Nanosim, Card two supports NanoSIM card or SD card, quite a few friends really feel that if they would like to use a memory card, they can only place 1 SIM card, so it is actually not possible to utilize dual SIM cards, which is a bit of a loss feel. So is there a good technique to use dual SIM cards and memory cards at the similar time, in truth, this approach is there, many folks have written just before, by way of DIY can make the memory card and SIM card share a card slot, Despite the fact that there are various tutorials on the web, currently I would like to share this process with you meticulously. https://pbase.com/topics/rangepants04/a_lot_of_modest_close_friend are as follows:

The very first step: prepare tool scissors, 502 glue, knife, MICROSIM card, or nanosim card, memory card;

Step two: Prepare the SIM card, micro card or Nano card to be used! Initially reduce off the plastic parts around the micro card or Nano card with scissors to reduce only the chip element, then make use of the blade to gently pry off the chip. When prying off, make use of the blade to force in diverse directions. The chip is also glued for the plastic, recall that brute force should not be employed, so as not to pry the circuit on the chip. Take diskgetor data recovery of prying the chip to remember the path on the chip, so as to not install the incorrect chip direction behind;

Step 3: Scrape off the bottom of the chip exactly where the plastic component is lifted gently with a blade, simply because the bottom of your chip is protected and raised, in order to prevent the back in to the card slot, so Have to have to scrape off several of the raised parts;

Step four: Examine the SI | M card chip with the SD card. If there is no size distinction, you could directly stick to the SD card. If there is a difference, make use of the prepared scissors to cut the identical size on each sides of your card. Put it on the opposite side of Cato and make a gesture to determine if there is any gap on each sides. Do not cut a lot of, or the contacts will probably be broken!

The fifth component would be to stick the SIM card chip with 502 on the side from the TF card out point. The distance above the edge is about 1MM away from the gold finger! data recovery software for windows 10 'll be able to place the SD card within the card slot for comparison. After the comparison, paste it with 502. data recovery software wants to become stuck in the middle on the left and ideal from the SD card (check the path of the SIM card chip between the phones just before sticking, and paste it) At that time, do n’t get glue to the position of the gold finger with the SD card plus the point of your sim card chip, otherwise it'll trigger the inability to contact or the memory card to be unusable);

Within the last step, put the sd card and Nanosim card together within the card slot and set up it within the phone. Keep in mind, when you ca n’t set up it, do n’t use brute force, shake the card slot, and slowly install the card slot into the phone. Otherwise, it's simple to make the SIM card unusable.

See the final impact, dual card + SD card, no longer must worry about being unable to make use of two SIM cards, or can only use a single SIM card and one particular SD card.

------ For additional tutorials, please remain tuned ------